FAQ CAT commands filter

Discussion in 'X-108' started by Chuck1101, Oct 4, 2020.

  1. Chuck1101
    Offline

    Chuck1101 Beginner X-108 Member

    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    1
    Gender:
    Male
    Ratings:
    +0 / 0 / -0
    Rufzeichen/Call:
    KD9DVB
    Have the CS-108G+ rig. Using it with FLRIG & FLDIDGI for running psk31 through a raspberry pi 4B. Have to define radio as ICOM IC-7200 to get rig control. Choosing IC-7000 to emulate does not work for me.

    My rig defaults to the 0.5 kHz filter on startup. Can change to either the 2.3 kHz or 6.0 kHz filter either from the radio front controls, filter button on the mic, or changing modes either from the mic or on radio front. Changing modes from either flrig or fldigi does not change filter setting.

    Have been testing various command codes from the IC-7200 manual. Can change frequencies, modes, etc., but no luck changing the filter setting. Any help would be appreciated. If interested in learning about sending command codes, please post and I'll try to help.

    Thanks
    Chuck
     

Share This Page