X-108 Info x108g mars cap ?

Discussion in 'X-108' started by Illusi0ns, Jul 19, 2017.

  1. Illusi0ns
    Offline

    Illusi0ns Chef-Boarder X-108 Member

    Messages:
    14
    Likes Received:
    2
    Trophy Points:
    3
    Gender:
    Male
    Location:
    vk3
    Ratings:
    +4 / 0 / -0
    Verified User:
    YES
    Rufzeichen/Call:
    Vk3fail
    serial starts in cxg

    i looked at one mod provided here but board looks difrent min dont seen to have numbers one one board
    apart from x108g ssigbd-v1.42.8rtm
     
  2. Johnny
    Offline

    Johnny Beginner X-108 Member

    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0 / -0
    Rufzeichen/Call:
    N2jrw
    Mine was the same way. But on the picture provided I took a chance and removed the jumper that was basically in the same spot as the one shown. And it worked for me. Not sure if you have tried this already. Good luck
     
  3. Adam Farber
    Offline

    Adam Farber Junior Boarder X-108 Member

    Messages:
    7
    Likes Received:
    0
    Trophy Points:
    1
    Gender:
    Male
    Ratings:
    +0 / 0 / -0
    Rufzeichen/Call:
    W4AJF
    Hi guys, new here...The mod says to take off the back panel but the SO-239 is attached, do you really have to take off the back panel? Thanks, Adam
     
  4. Richardiii
    Offline

    Richardiii Beginner X-108 Member

    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    1
    Gender:
    Male
    Ratings:
    +0 / 0 / -0
    Rufzeichen/Call:
    ve3rdz
    Cs108g+ model i have remove front knobs and screws and bottom screws and back screws the board will pull out from the back not the front flip over and u will find that resistor near the front as shown in diagram it worked great for me open tx everywhere
     

Share This Page