X-108 Info Amplifier for X108G - PTT (1 Viewer)

[Oleg Kulagin]

Hi all.

Somebody to connect an external power amplifier to the transceiver X108G? Where to take from the transceiver output PTT for amplifier relay? Mini DIN 6 ACC have not it.

 

[Gilles VE2GIQ]

Hi all.

Somebody to connect an external power amplifier to the transceiver X108G? Where to take from the transceiver output PTT for amplifier relay? Mini DIN 6 ACC have not it.

Try this out !

 

[Oleg Kulagin]

Thanks for the info. But I solved the problem easier. Amplifier I turn on by the pedal with the foot, and the transceiver - with the tangent.

 

[TNBOB]

Hi all.

Somebody to connect an external power amplifier to the transceiver X108G? Where to take from the transceiver output PTT for amplifier relay? Mini DIN 6 ACC have not it.

Hi Oleg, once I can get my hands on the schematics I will try to locate what you need. 73, KE5QLX

 

[Oleg Kulagin]

It took more than a year, the guarantee was over, and I decided to modify my radio. Set the relay to connect an external amplifier.

This requires two parts. Connector for connecting video - audio equipment with a thread diameter of 6 mm, and a small-sized relay for 9 volts. I used the Soviet relay

You must be registered for see links

(02.01), This is a very good relay, it was used in military and space technology in the USSR, the content of precious metals in relay РЭ49 РС4.569.421.00.01, РЭС49 РС4.569.421.01.01, РЭС49 РС4.569.421.02.01, РЭС49 РС4.569.421.05.01.

Gold: 0.000525 grams.
Silver: 0,02937 grams.

You must be registered for see images

The connector for grounding should be removed, its diameter is exactly 6mm, I drilled it in a vice.

You must be registered for see images

You must be registered for see images

You must be registered for see images

Now you need to remove the small connecting cables of reception and transmission, which connect the upper and lower modules. Be extremely careful! The earthing of the cables is soldered, it needs to be cleaned very neatly, and when assembled, soldered back. Do not damage them with a powerful hot soldering iron!

You must be registered for see images

Carefully install the disassembled transceiver for further work. Take care not to damage the connecting lines of the processor and the display!

You must be registered for see images

Now you need to find the point TP8B on the amplifier board. This is a voltage output of 9 volts for inclusion on the transmission.

You must be registered for see images

Solder to this point a thin quality wire for the relay.

You must be registered for see images

Install the relay. How I installed our Soviet relay, can be seen in the photographs. Probably you will use other relays, then the technical solution depends only on your imagination.

You must be registered for see images

Now You can mount the transceiver in the reverse order.
DO NOT HURRY! ACCOUNTABILITY IS IMPORTANT!

You must be registered for see images

We make grounding. I hope you do not need to explain how.

You must be registered for see images

All is OK now!

You must be registered for see medias