Discussion in 'X-108' started by Illusi0ns, Jul 23, 2017.
Does this work for all X108G models?
Where can I find my X108G version?
the guy i bought mine off asked the suppler an the answer i got was yes
Thank you - made it - and it works really fine. Thank you!!
no problem, your welcome
now back to working on my homebrew tuner with 2x 460pf just gotta make the coil for taps
Works as shown effortlessly.This enhancement was done as I decided that I had had quite enough of the Loose usb jack disconnecting from the P.C. Rig control software during operation, so I called and ordered a higher quality solid mount ,Also Powerpoles and a fusible mounting bracket to replace the simulated D.C. input that it came from the factory with. Also while open I improved the board to case grounding wherever possible.I noticed as well the Rj45 plug was loose and had a visible cold solder joint.So 100% Q5 rig after a couple months now and the Receive static floor level is a solid 3db lower since then.
you may have interfearance plaz a few houses down ?
Not that I am aware of.Most of R.F. is 20 ft. above 2nd. story roofline,and I am properly earth grounded,and 3KW L.P.F. inline after SB-220,and before swithchbox and RF Choke.I speak to them a couple x a week with no mention.Maybe just good neighbors??IDK?
tested and working ok
One question though, what will be the TX frequency range then?
Okay, one more question, what sort of backup battery is that on the picture?
I must change it for a new one, and it seems like a CR2016, or a CR2032.
It seems there are two lithium batteries in the X-108G. I think the one in the picture is for the RAM for operation of the radio. de Frank KG9H
Separate names with a comma.