X-108 Info X108G microphone? (1 Viewer)

[Roberto]

I'm an owner of X108G without its microphone... I've lost it!
I tried to use an ICOM one (from ID880), buttons work but PTT not.
So I'm searching a dealer online to buy it, can you give me some infos?

Thanks!!

 

[X-Boarder]

The microphone is by the way not identical with the one for the IC-7000 and not only because of the differently printed buttons. If you open the micro, the HM-133 is on the board as with the corresponding Icom model. In the first series, which I still have, the circuitry was also identical, that is, the PTT was switched via microprocessor and not via the PTT switch directly. The second generation (2nd batch), which is currently among others. From

You must be registered for see links

, has a somewhat rebuilt microphone circuit with adapted firmware. The PTT is now "hard" wired. With an Icom microphone (without conversion) you can now no longer send. "

take a look here: X-108 - xiegu x-108 microfone schematics | Xiegu X-108 - QRP Transceiver - HamRadio - QRP Forum

 

[OA4LDR]

Rj45 microphone pinout please???? 73s

 

[ZL1SAM]

Rj45 microphone pinout please???? 73s

is it not in the schematic file?

 

[Pat Hamp]

Its also the same as the 5105 there is one on Ebay.

 

[AvaMartin]

Hi...the radio is not merely an SSB/CW rig. (Rig has CW keyer built in). It also works and is used by hams on AM and Digital modes. The output power is variable although being somewhat conservative, I keep mine set at 15W. No one can tell the difference at the other end.
Frequency stops and some other operating controls are very similar to the IC-718 so there is a very small learning curve for Icom users. The operator's guide has 30 pages and the essentials can be read in less than five minutes. An outboard/computer speaker (stereo!) is recommended if not using stereo headphones. The radio's speaker is designed for communications only.

 

[Alezis]

I supposed it would be the same pinout for the non G version right ?

 

[Illusi0ns]

2 pwr 3 ptt gnd 4 ptt 5mic gnd
av508 deskmic hooks straight up but only ptt an lock work an the power button